System Components
The system contains the following basic components:
T250 Laser Source |
R545 2-axis Laser Receiver |
Test Coach |
Mounting for the Laser Source |
DU320 UMPC with Touchscreen |
Software ProLine |
|
This website uses cookies, which are necessary for the technical operation of the website.
Other cookies will only be used with your consent. Privacy.
Configuration
The system contains the following basic components:
T250 Laser Source |
R545 2-axis Laser Receiver |
Test Coach |
Mounting for the Laser Source |
DU320 UMPC with Touchscreen |
Software ProLine |
|
Case study:
The tube has a diameter of 518 mm. The test coach ist accordingly preset.
Handle with care. Do not tilt the test coach in the interior zone of the tube.
Notches
Before mounting the laser source you need to make a cone lowering at the exterior of the tube that fits to the mounting. This is very important for sure fit of the laser source.
At the mounting device for the laser source each of the three tralges has a thorn that fits to the particular notch.
After adjusting the laser correctly you can start the measurement.
In case you have earned a complete measurement system of Status Pro (including display unit and software), the complete installation will be done automatically. You only have to unpack, switch on and measure.
Choose between three types of measurement:
|
|
© 2024 Status Pro | Status Pro Maschinenmesstechnik GmbH · Mausegatt 19 · D-44866 Bochum |